TVOC Air Quality Monitor

FAQ

1.How to make sure that the sensor is connected with the hub?

Press the reset button of the Motion Sensor. If the hub sounds the voice prompt "Connection is normal" or "beep", it means that the communication between the sensor and the hub is normal; if there is no voice prompt, please try to connect the sensor to the hub again; if there is still no voice prompt, the battery of the sensor may be dead, and please replace the battery and try again.

2.What causes the sensor connection error? How should I connect again?

1. The device may be too far away from the hub. Please move the sensor closer to the hub and add the device again.
2. Make sure the hub has connected to the network."

3.What are the possible reasons why the sensor gets frequently offline?

1. The device is too far away from the hub;
2. The battery is low or dead;
3. The sensor is installed on a metal surface and the signal is disturbed."

4.How to reset the sensor? Under what circumstance?

Long press the reset button of the device for 5 seconds, the indicator light flashes 3 times, and then the factory settings are restored.

5.Why does the TVOC value not be displayed for a period of time after start-up, network connection or battery replacement?

At the moment, the sensor is being initialized, and the value is temporarily not displayed until the data is stable and reliable. This period of time lasts about one to two minutes.

6.Why does the screen display update slowly?

To reduce power consumption, the display will update only when the data changes.

7.How to switch the interface?

Double clicking the button can switch the interface.

8.Can it work normally below 0 ℃?

When the temperature is lower than 0 ℃, the screen display may not work well. When the temperature is higher than -20 ℃, the data can be collected and reported normally.

9.Why does the screen flicker sometimes?

This is determined by the characteristics of the e-ink screen, and the screen flickering may occur several times when it is refreshed, which is normal.

Specifications

Model

AAQS-S01

Color

White

Product Dimensions

41.6 × 76.0 × 14 mm (1.64*2.99*0.55 in)

Battery

CR2450 × 2

Wireless Protocols

Zigbee 3.0 IEEE 802.15.4

Operating Temperature

0°C~+50°C (32°F~122°F)

Operating Humidity

0~95% RH, no condensation

TVOC Detection Range

0~25 mg/m³

TVOC Resolution

1ppb or 0.01mg/m³

Temperature Detection Range

-20~60℃ (-4~140°F)

Temperature Resolution

0.1℃

Humidity Detection Range

0~100%RH

Humidity Resolution